Click the link below for the pdf version of Stewart Warner Add-On Shift Light Install Sheet Stewart Warner Add-On Shift Light Install Sheet [thanks to Stewart Warner used with permission]
Tag Archives: installation
Stewart Warner B806 Exhaust Temp Gauge Install Sheet
Click the link below for the pdf version of Stewart Warner B806 Exhaust Temp Gauge Install Sheet Stewart Warner B806 Exhaust Temp Gauge Install Sheet [thanks to Stewart Warner used with permission]
Posted in Electrical, Engine, Exhaust Also tagged engine diagram, gauge, performance Comments closed
Another Pyrometer Installation
A. THERMOCOUPLE INSTALLATION – The R650 Thermocouple mounts into a 1/4″ pipe thread. If the exhaust manifold is already drilled and tapped, install the thermocouple at that location. If none is provided, make a 3/4″ hole in the exhaust pipe, not more than 6″ below the exhaust-manifold-to-exhaust-pipe connection and weld the R680 bushing into the […]
Posted in Electrical, Engine, Exhaust, General Also tagged engine, gauge, performance Comments closed
Pyrometer Installation
See Universal Installation Guide for Installation on Turbo Down Pipe 1. Remove turbo from exhaust manifold. 2. Stuff a small shop towel or rag 4 to 5 inches into the rear exhaust manifold passage (see pic below) through the turbocharger mounting flange. This is to prevent chips from entering the manifold while drilling and tapping. […]
4 Inch Aftermarket Exhaust Installation
In the shop, ready to get started. The original tailpipe. This picture clearly shows the difference in size between the old exhaust, and the new! The setup for the new exhaust, showing the front aftermarket 14 inch long anti-drone muffler, and the standard muffler further down – both are straight-thru design mufflers. A view from […]
