Post Your Successful Diesel Mods At Dieseldatabase

By Dean Isaacson | Published: 7 Mar 2011

Have you completed a successful mod on your diesel truck? and did you take pictures and discovered tips that might help others? Your post is welcome here. All you have to do is register on this site. Then contact us via the the contact form on the ABOUT page (see menu), letting us know you […]

Twin Turbos on a Powerstroke Diesel

By dzljim | Published: 24 Oct 2010

A big thanks goes to John Anderson for being the Pioneer on this type of project and sharing his project with all of us. In that same spirit, I threw some pics into a collage to be able to share what I can now, until I can do a formal write up for this site. […]

On Board Air Tank

By dzljim | Published: 23 Oct 2010

It’s always handy to have compressed air with you for filling your flat tires, other people’s flat tires, air horns, blowing mulch or straw out of your bed, the list can go on and on.  I use compressed air mainly for my air horns. I’ve had a 9 gallon air tank in my aluminum bed […]

Dodge 12V Cummins Throttle Cable Replacement

By unknown | Published: 24 Oct 2010

Throttle cable failure has been common on 1994 – 1998 12 valve diesel engines, usually after about 30,000 miles on the cable. I am now on my third cable, and am curious to see if the new design will be more reliable. Twice I have managed to replace my cable in the nick of time […]

Stewart Warner B754 Gauge Pods Install Sheet

By unknown | Published: 10 Nov 2010

Click the link below for the pdf version of Stewart Warner B754 Gauge Pods Install Sheet Stewart Warner B754 Gauge Pods Install Sheet [thanks to Stewart Warner sw-performance.com used with permission]

Crankshaft Position Sensor Replacement

By unknown | Published: 23 Oct 2010

(1) you need to disconnect both negative battery cables at both batteries. I used a 1/2 inch deep socket to remove the cables from the battery terminals. (2) Remove starter motor to get to CKP. The sensor is located on the driver’s side of the engine with the starter motor placed in front of it. […]

Cleaning Stickum Left From Vinyl

By Dean Isaacson | Published: 23 Oct 2010

Just after the winter began winding down and the weather was beginning to warm up, I removed a large 30″ x 18″ vinyl sticker from the tailgate of my truck. No matter how much heat was applied, the back of the sticker refused to come loose. I tried everything, Goof-Off®, fingernail polish remover, paint thinner, […]

Waste Gate Mods

By dieselminded | Published: 10 Nov 2010

The simple explanation: a waste gate limits the maximum boost generated by the turbocharger. How it works and what it does: The waste gate uses a pressure activated diaphragm and rod to operate an exhaust bypass around the turbocharger and thus limit the maximum boost that the turbocharger can produce. This permits an engine manufacturer […]

12V Cummins Governor Lever Adjustment

By unknown | Published: 23 Oct 2010

Here is the ins and outs of the secret governor lever adjustment This is a cut away view of the governor of a P7100 pump. Notice how the lever hit the cam plate flush at the very bottom edge. To check your adjustment the throttle lever needs to be moved until the lever just touches […]

Repair Under Hood Weatherstripping

By John Donovan | Published: 10 Nov 2010

Tired of always finding the weather strip laying on top of the turbocharger in the engine compartment? A bead of silicone rubber RTV in the weatherstrip groove will keep the strip attached and eliminate the fire danger. Red RTV or high strength gray RTV is my favorite for this type of work. Black RTV would […]

Dodge Cummins Intercooler Boots and Upgrades

By unknown | Published: 23 Oct 2010

Are your intercooler boots & hoses blowing off? This is a common problem with the Ram Diesel especially for those who love high boost pressure. Stock intercooler boots & hoses have been blowing off at as little as 25 PSI which can ruin your day if you are racing at the track or pulling that […]

Diesel Troubleshooting Chart

By unknown | Published: 24 Oct 2010

Complaint ————-> Probable Cause WillNotStart HardToStart StartsAndStalls DiesOnDeceleration RunsRough LackOfPower BlackSmoke WhiteSmoke Low Cranking Speed X X             Incorrect StartingProcedure X X             Some or All Glow Plugs Bad X X     X     X No Fuel to Cylinders X       […]

Dodge 12V Cummins Fuel Shutdown Solenoid

By unknown | Published: 23 Oct 2010

To check the fuel solenoid adjustment: 1. Turn the key on but do not bump the starter 2. Get under hood and pull up the solenoid by hand (it will stay up when you let go). 3. Measure from the bottom of the solenoid mounting bracket to the top of the lever pin as shown […]

My Glowplug Relay Bypass System

By dzljim | Published: 23 Oct 2010

There have been many threads on the glow plug relay bypass idea discussing how and when to turn off the relay, and even whether or not it is a good idea at all. I have come up with a combination of ideas that I feel is the best scenario. How the glow plugs work depends […]

Anti-Freeze Replacement

By unknown | Published: 23 Oct 2010

From Steve St.Laurent : Here’s how I did mine and I got approximately 5.5 gallons into the system, first I opened the petcock on the radiator (turn it, then pull on it a little, turn, pull, turn, pull – until it starts draining), that will drain the fluid out of the overflow bottle, once the […]

Ford 7.3L Diesel Fuel Tank Vent Mod

By dzljim | Published: 23 Oct 2010

About one month after I completed the extraction and re-installation of the PSD from my truck, necessitated to replace a rusted out oil pan, I noticed diesel fuel on the floor of my garage under the rear of my truck.  Sure enough the steel rear fuel tank had also rusted through.  Why in the world […]