I built this setup from scratch and ran it for only 1 month before removing and reinstalling my 4″ system. This system sounded very good but had some draw backs that I couldn’t live with including noise and smoke for passengers in the back and soot showers on startup after a rain or carwash (there […]
(1) you need to disconnect both negative battery cables at both batteries. I used a 1/2 inch deep socket to remove the cables from the battery terminals. (2) Remove starter motor to get to CKP. The sensor is located on the driver’s side of the engine with the starter motor placed in front of it. […]
One of the most frequent questions I get on the Cummins powered Dodge trucks is transmission related. The Dodge automatic tranny is very robust and does what it was intended to do very well. But given the reputation for massive torque that the Cummins engine provides, many times the transmission is asked to do far […]
This is a NEW USERS guide to gauge install preparation. I wish that I had something similar to this when I started this project. So I have assembled the information in this document with the goal of helping people to prepare for installing gauges. Some of This information has been obtained from Turbo Diesel Registry […]
Special Thanks to Stamey’s Website for this FAQ about the 53 Block What is the “53” block? The “53” comes from a casting number on the side of the block and is used to identify the problem blocks. Supposedly it affects about 100,000 blocks, but not only in Dodge Rams. Here is information regarding the […]
It has been two years – sorry for the long delay in getting the site back up. We changed our minds several times on how we were going to rebuild – the rest of the time, we were just too darn busy. The old DieselDatabase.com sites revolved around aliased URLs (cumminsdatabase.com, powerstrokedatabase.com, duramaxdatabase.com, peterbiltdatabase.com, and […]
A silencer ring is a metal baffle placed into the turbocharger inlet to reduce whistle from the turbocharger. It is installed in Ram truck engines at the request of Chrysler. The silencer ring has no effect on engine output, EGT, or boost levels. Removal: Remove the flex hose from the front of the turbo that […]
Symptom/Condition: The vehicle may not warm completely, especially in cold ambient temperatures. This condition may be due to a thermostat that is stuck in the partial open position by debris in the cooling system. NOTE: THE COOLING SYSTEM USED ON THE CUMMINS DIESEL ENGINE EQUIPPED VEHICLES PROVIDES THE CAPACITY AND PROTECTION OF THE HIGHER GVWR […]
When Propane is added to the air intake usually the horn it ensures that all the Diesel is turned into Power. When propane is used properly, it will keep your engine cleaner with less carbon buildup and cleaner oil. Propane is a high-octane fuel and burns slower and longer therefore, propane will help diesel burn […]
That I take my vehicles to a mechanic, even for minor problems, makes me spoiled in some respects. Though I have disciplined myself to change wiper blades, fuses and light bulbs. Nonetheless, when I looked the throttle body spacer over, I took up the challenge to install the unit myself. This isn't a hard one. […]
Post Your Successful Diesel Mods At Dieseldatabase
Have you completed a successful mod on your diesel truck? and did you take pictures and discovered tips that might help others? Your post is welcome here. All you have to do is register on this site. Then contact us via the the contact form on the ABOUT page (see menu), letting us know you […]