This documentation is intended to be used as a visual overview only and is not meant to be used as a replacement for a service manual. Please consult your Dodge service manual for complete instructions on the removal and re-installation of an injection pump The truck in this project is a 2000 Dodge Ram 3500 […]
Note: Tip 3 is the only one that applies to a Ram pickup TIPS FROM AUTOMOTIVE PRODUCTS, INC. Automotive Products, Inc., the supplier of the Pre- filled Hydraulic Clutch Actuator Assembly for the Dodge Ram (BR), the Dodge Dakota (AN), the Jeep Wrangler (TJ), and the Jeep Cherokee (XJ), has some valuable tips for Automotive […]
With this guide we have a donor charger so Removal of the charger is not included Refer to the Charger Swap Guide for further information Completion time: Less than 2 Hours Here’s a 16cm Holset Exhaust Housing Here’s the Exhaust Gasket Here’s the Oil Return Line Gasket Here’s the donor charger This set up is […]
Lem stayed up late the night before and was working into the morning installing the Snow Performance water/methane injection system on his 2002 Cummins. As a result, we were late to the Dyno Drags for this year’s Diesel Thunder hosted by Northwest Bombers (local division of TDR). I and our friend Thom, who was working […]
Start inside the truck. With a Phillips remove the screws holding the shift boot and slide it up. Remove shifter with 3/4″ or 19mm wrench. Pop up transfer case shifter boot and remove bolt/s. Pull out rubber inserts in cupholders and remove bolt/s. Remove plastic shroud. Unbolt shifter boot. Unbolt shift tower carefully and tape […]
This mod article will walk you through the steps of installing a Fast Idle Switch. Application: ’05 6.0 PSD with Torque Shift Transmission. Tools Required: 10mm socket with extension and ratchet Wire striper, cutter, crimp tool At least 5 feet of wire (12-14 gauge, color is user defined) 2 sets of butt or spade […]
A. THERMOCOUPLE INSTALLATION – The R650 Thermocouple mounts into a 1/4″ pipe thread. If the exhaust manifold is already drilled and tapped, install the thermocouple at that location. If none is provided, make a 3/4″ hole in the exhaust pipe, not more than 6″ below the exhaust-manifold-to-exhaust-pipe connection and weld the R680 bushing into the […]
Post Your Successful Diesel Mods At Dieseldatabase
Have you completed a successful mod on your diesel truck? and did you take pictures and discovered tips that might help others? Your post is welcome here. All you have to do is register on this site. Then contact us via the the contact form on the ABOUT page (see menu), letting us know you […]